The table below shows information about the current software release for the .edge processing blades.

If more than one blade is installed, then it is recommended to run all processing blades on the same and latest release version.

Current ReleaseLink to Current Release

.edge ReleaseCompatible with...

Version 3.0.24

17.03.2025

RELEASED

  • Software Version: 3.0.25

 
FPGASpeedGrade 1SpeedGrade 2

VersionTimestampVersionTimeStamp

25G+CC+AM

v2.2.9809/12/24 10:52:02v2.2.98

07/01/25

01:50:49
100G+CC+AMv2.2.98

06/12/24

22:34:45		v2.2.98

06/01/25

21:33:24
100G+25G_Proxy+AMv2.2.98

09/12/24

20:30:08		v2.2.98

08/01/25

16:58:33
100G+25G_Proxy+CCv2.2.98

06/12/24

18:27:12		v2.2.98

07/01/25

03:01:43
100G Proxy (IP<>IP)v3.0.2

08/01/25

11:04:01		v3.0.2

08/01/25

10:53:18

.edge integrates natively with HOME.

.edge supports the following interface solutions:

A: The software version of each processing blade can be checked from the "Identify" page in HOME's Advanced parameters.

In addition to the main software Version, it is important to note the FPGA Version and FPGA Build Time.

A: The installer for each release is available from the Lawo Download-Center (after login). Once you have downloaded the correct file, you can use the "nodesys installer" tool to perform the update (via the control network).

For full instructions, see Updating a Processing Blade.

Previous Releases

There are no previous releases to document.