Each Power Core frame is delivered in its own box with all included accessories. If you have ordered any expansion I/O cards or the DC power supply, then these are packaged separately, along with the optical transceivers.

The license codes for all software licenses can be found on the delivery note (included with the shipment).

A list of serial numbers for the hardware components is also included. Please keep this list for your records.

Please check the contents of the shipping boxes, and in the event of any transport damage, contact your local Lawo representative or email support@lawo.com.

Packing List

The contents of the shipment will vary depending on the component(s) ordered.

Included

The following items are included with each Power Core frame:

  • 1 x 2m IEC power cable (country-specific) - to connect AC mains to the frame.
  • 1 x USB license dongle (250-5998-000).
  • Dust caps for the Network Interface and MADI SFP cages - these will be mounted in the frame.

If you have ordered a revision 2 frame, then you will also find 1 x serial cable (485-0700-000) - to connect to the RS 422 port (for diagnostics).

Note that the Power Core license code (for the USB dongle) can be found on the delivery note.

Optional

The following items are optional and must be ordered separately:

  • Up to 8 x rear expansion I/O cards - for audio and GPI/O interfacing.
  • 1 x external DC power supply (955/50-80) with 2m IEC power cable (country-specific) - to connect DC power to the frame.
  • 1 x USB license dongle safety cap.
  • Optical transceivers - for the network interface and MADI ports.

As a first step, any expansion I/O cards should be fitted into the frame. See Fitting an I/O Card for instructions.

Not Included

The following items are not included and must be provided by the customer or installer:

  • Ethernet cable(s), optical and/or copper - to connect the media and management ports to the network, or directly to an IP control surface.
  • CAN bus cable(s) - to connect external KSC or GPIO panels, and/or a CAN-bus control surface.

If you are planning to control Power Core from VisTool, then the following items are also required:

  • Windows 64-bit host PC - to run the Lawo application VisTool.
  • Ethernet cable(s) - to connect the host PC to the network.

The following document contains more information about the host PC requirements: Vistool PC Config.pdf.