There have been three revisions of Power Core since its first introduction. The table below summarizes the main differences.

This user manual describes the current revisions (2 and 3) unless otherwise stated. Note that all Power Core devices are configured and operated in a similar manner.

Power Core FrameType NumberSummary of differences

Revision 3, Current


710/13


Changes from revision 2:

  • Added 2 x RAVENNA/AES67 interfaces (ra2, ra3). This doubles the maximum number of streams/AoIP channels.
  • Easy access to SD card (from front) for data backup/exchange.
  • New USB type B server port (at front) for diagnostics.
  • Removed GPIO (from front) to make way for new features. GPIOs can be added via rear expansion I/O cards.

Revision 2, Current

710/11

Changes from revision 1:

  • All network interfaces changed from RJ45 to SFPs, to support a range of cable types and connectors.
  • Added 1 x network control interface (dwc1).

Revision 1, Discontinued

710/10

First release.

  • 1 x network control interface (dwc0).
  • 2 x RAVENNA/AES67 interfaces (ra0, ra1).
  • All network interfaces available via RJ45.
  • GPIO included (at front).