This topic describes the pinning information for each of the main frame connectors and expansion I/O cards.

Main Frame Connectors

CAN

8-pin RJ45 connector, female.

RS-422

8-pin RJ45 connector, female.

DC Power IN

4-pin Kycon connector, female.

GPIO on front panel (revision 2 frames only)

37-pin D-type connector, female.

For voltage/current specifications, please refer to the data sheet for the Power Core frame (710/11).

Expansion I/O Cards

MIC/LINE IN (710/20), LINE IN (710/25), LINE OUT (710/30)

25-pin D-type connector (DB25), female.

Pinning and gender according to AES59 (TASCAM) standard. All shields are internally connected to system ground. 

STUDIO I/O (710/35)

25-pin D-type connector (DB25), female.

Pinning and gender according to AES59 (TASCAM) standard, except for Phones. All shields are internally connected to system ground.  

AES3 I/O (710/41, 710/40)

25-pin D-type connector (DB25), female. 

AES3 inputs 1..4 (RCV1..4), AES3 outputs 1..4 (XMT1..4).

Pinning and gender according to AES59 (TASCAM) standard. All shields are internally connected to system ground.

AES3id I/O (710/42)

8 x HD-BNC, 75 ohm.

AES3 inputs 1..4, AES3 outputs 1..4.

MADI I/O (710/50)

2 x MADI optical (via SFP).

Connector and fiber types depend on the SFP module.

MADI I/O SRC (710/60)

1 x MADI optical (via SFP).

Connector and fiber types depend on the SFP module.

DANTE I/O (710/55)

2 x DANTE (dual-redundant ports).

RJ45 connector, standard pinning for CAT5 cabling.

GPIO (710/80)

37-pin D-type connector, female.

For voltage/current specifications, please refer to the data sheet for the I/O card (710/80).