A stereo downmix can be created from a surround channel as follows. 1.Open the Channel Config display on the Central GUI. 2. Select the Surround VCA master - either via the Signal List display or Access/Assign panel. 3. Turn on the Downmix option. Note that, to enable the Downmix option, you must have a Surround VCA master in access. Channel Config display Once Downmix is enabled, a stereo (and mono) downmix are created. They appear automatically under the DSP Outputs in the Signal List display. From here they can be connected to a destination in the usual manner. Signal List display By default, all channels contribute equally to the stereo downmix except the LFE (which is turned off).
To adjust the downmix levels:
1. Select Downmix Faders in the Channel Config display. 2. Use the on-screen faders and Mute buttons to adjust the downmix matrix levels or mute a channel. Channel Config display 3. When you have finished editing, touch X at the top right to close the pop-up. The settings for each downmix are stored within productions, so remember to save or update a production to save any changes. By default each matrix is isolated so that it will not be affected by a snapshot load.
